Electric control system conforms to UL,CE
standards.
Automatic Capsule
Filling Machine is described station by station
1.
Empty gelatin capsules are fed from a storage
hopper to the rectifier, and
inserted with the aid of vacuum into one of the 12sets of
carrier segments;
each carrier segment holds 5empty capsules
2.
The carrier segment's upper holder holding
the caps is now lifted; separation of
cap and body is assisted by vacuum
3.
The upper holder starts retracting while
the lower proceeds to the dosing station
4.
Complete retraction of the upper holder is
done at this station
5.
Powder slug is inserted into
the capsule body; when there is no capsule body held
at the lower holder, the powder slug will be further pushed
downward and collected in a receiver tray
6.
Two station reserved for attachments to fill
pellets or other granulated products
7.
Two station reserved for attachments to fill
pellets or other granulated products
8.
Ejection of un-separated capsule or the up-side-down
capsule caps is performed
with an aid of 5upward stroking rods
9.
Upper holder starts moving
outward to the position above the lower holder
10.
At this station, while upper
and lower holders are closely matched the capsule
bodies are pushed upward into the caps by 5 steel rods
11.
Now the closed capsules arriving at this
station are again pushed upward by the
other 5 steel rods and leave the carrier segment
12.
Carrier segment is vacuum-cleaned and proceeds
to the capsule insertion station
Technical
Data
Capacity
36,000~40,000
Capsule Size
#00, #0, #1, #2, #3, #4, #5
Power supply
220/380V , 3 PHASE , 50/60Hz
(For customer to designate)
